How To Attach A Stud Wall To Vinyl Siding

The block should be rectangular and large enough to accommodate the base of the fixture.

How to attach a stud wall to vinyl siding.

Christmas lights are a great example or maybe a hanging plant. Find a stud roughly where you want to be inside the house. Temporarily nail or brace the ledger in place positioned and leveled at the desired height. Many times rather than using nails screws of various sizes are required and preferred.

Screws must be centered in the slot with approximately 1 32 0 8mm space between the screw head and the vinyl. Screw fasteners can be used if the screws do not restrict the normal expansion and contraction movement of the vinyl siding panel on the wall. Cut a mounting block out of 1 inch lumber to mount a fixture on vinyl or clapboard siding. If it is impossible to attach the ledger to a floor joist then fasten the ledger to wall studs which are generally located on 16 inch or sometimes 24 inch centers and doubled up around doors windows and other openings.

It slips into the groove between adjoining slats and once it clicks into place you can hang items as heavy as 12 pounds. Each panel should be able to move back and forth or the siding will bubble on really hot days. Measure inside from stud to reference point then go outside and measure off the same distance from your reference point. Don t drive the nails tight.

X research source measure the wall before you start installing the panels so you know exactly how many panels and partial panels you need to use. 2 turn on a stud sensor and. Most homeowners who are lucky enough to have vinyl siding find that sooner or later something needs to be attached into the siding or trim. Mark a horizontal mark on the siding with a carpenter s pencil at the trellis top.

For example if the wall is 11 feet 3 4 m long and each siding panel is 2 feet 0 61 m long you would need 5 panels and 1 half size panel. Remove one or two runs of the vinyl as needed mount the awning directly to the wall install j channel around the awning then cut the siding you took off so that it will go into that j channel. Then you ll want longer ones. Hold your wooden trellis up on the vinyl siding at the height you want to hang it.

Most hooks are stainless steel so they won t corrode and they are easy to remove when you re done with them.