How To Attach Vinyl Siding At The Top

Measure the gap remaining at the top of the wall.

How to attach vinyl siding at the top.

The most common approach here is to install sill trim at the soffits rip down the top course of siding and crimp the siding so the sill trim holds it in place. Using a piece of scrap siding as a template measure the width of the second to last row marking it with your pencil. Position a nail at the top of the upper slot on both sides of the corner post leaving a gap of approximately 1 32 0 8mm between the nail heads and the corner posts. Soffit and fascia starting with the soffit nail lengths of j channel against the inner edge of the fascia board.

Score the vinyl siding at the mark and break off the excess top by. If the result is a whole number you re in. You must leave the bottom. But if the result is not a whole number you will need to cut the final piece of siding lengthwise in order to fill in.

How to install the top row of vinyl siding step 1. Install siding as normal until you reach the second row from the top. Installing vinyl siding in these 23 steps step 1. Gap at all ends.

How to secure the last piece of vinyl siding. Secure the utility trim also called under sill trim just below the soffit using the same. This works fine most of the time but always add a few blobs of caulking inside the bottom lip of the top course for extra security. To prevent the relatively thin panels from buckling observe these fitting and nailing rules.

How do i put up a top piece of vinyl siding. Diy how to fix loose vinyl siding with a malco sideswiper siding tool. Place the corner post in position allowing a 1 4 6 4mm gap between the top of the post and the eave or soffit. Cut and install top j flush with the outer face of the side j s.

Snap the second to last piece of vinyl siding into place. Cut a tab in the bottom of the side j channels and fold under. Loosely secure it with galvanized roofing nails or exterior screws in the center. The siding slides behind vinyl siding trim pieces that hide the gap and the cut end.

Cut and bend drain tab. Install side j channels flush with the lower face of the bottom j channel and with the top of the window casing. Divide the length of each wall by 8 inches the width of a piece of siding. Use this template.

Soffit and fascia if the soffit on your home wraps around a corner as with a hip roof you ll need to make some.