How To Attach Vinyl Siding To Concrete Wall

1 2 inch 1 3 cm plywood or osb are common substrates and these are generally covered with roofing felt or another moisture barrier prior to siding the walls.

How to attach vinyl siding to concrete wall.

The contractor proposed using tapcons to attach the siding directly to the foundation which would allow the siding to line up with the first floor. There are hundreds of colors to choose from when you decide on installing vinyl siding. Measure the width of one block wall and cut treated two by fours to match. You want to nails these in to the block joint not the block itself.

Install the boards horizontally placing them flat against the. Furring strips are basically 1x3 or 1x4 strip of wood that are vertically nailed every 16 inches on center using masonry or concrete nails. The vinyl siding that around the concrete portion that i want to cover up is attached to an osb board that s attached to the framing of the house. You do not need tyvek if you are going over concrete and using treated furring strips.

How to install siding on concrete block house. You re on the right track. Yes i would put insulation board between the furring to add some support to the vinyl. Nail 1 1 2 inch thick wooden furring strips to the concrete wall at 4 foot intervals using concrete nails.

Install a strip of insect netting along the bottom edge of the concrete wall by nailing the. Insert a sleeve anchor into this hole and tighten the anchor enough to hold the furring strip in place. In effect i would need to add a bit of spacing between the concrete and the siding. The concrete foundation is nearly flush with the first floor siding meaning that using furring strips would cause the new siding to stick out.

After the furring strips have been installed vertically on the wall you may install any siding you wish. No you do not want the vinyl to come in contact with the ground the siding could deteriorate. Place the strip so its center is lined up with the vertical line. Easiest and only way to install vinyl siding over the cinder block wall is to nail on something called furring strips.

Vinyl siding is a great material to dress up a concrete block structure. As a result the osb protrudes about a half inch farther out than the concrete. Line up the hole in the strip with the top hole you drilled in the wall. Vinyl siding colors are not restricted to the limited five or ten pastel colors that were the choice for so many years.

Use nails that are no longer than the furring strips are thick so that they don t penetrate the concrete behind the strips which would cause the nails to bend and damage the siding. Remove any siding or exterior finish that isn t compatible with vinyl siding and make sure the walls are sheathed with a substrate to receive the siding. At the top of a furring strip drill a hole.